electrical ratings | |
---|---|
Voltage supply | 4.75...30 VDC |
Reverse polarity protection | Yes |
Short-circuit proof | Yes |
Consumption w/o load | ≤70 mA |
Initializing time | ≤30 ms after power on |
Pulses per revolution | 1 … 65536 |
Duty cycle | 45…55 % typical at 1024, 2048 ppr (further see table Duty cycle) |
Reference signal | Zero pulse 90° or 180° |
Sensing method | Optical |
Output frequency | Optical≤300 kHz (TTL) ≤160 kHz (HTL) |
Output signals | A+, B+, R+, A-, B-, R- |
Output stages | A+, B+, R+, A-, B-, R-TTL/RS422 HTL/push-pull |
Programmable parameters | A+, B+, R+, A-, B-, R-TTL/RS422 HTL/push-pullOutput level TTL/HTL Pulse number 1...65536 Zero pulse width 90°/180° Zero pulse position Signal sequence |
Interference immunity | DIN EN 61000-6-2 |
Emitted interference | DIN EN 61000-6-3 |
Approval | UL 508 / CSA 22.2 |
mechanical design | |
Size (flange) | ø58 mm |
Shaft type | ø10 x 20 mm, solid shaft with flat |
Admitted shaft load | ø10 x 20 mm, solid shaft with flat≤40 N axial ≤N radial |
Flange | Clamping flange |
Protection DIN EN 60529 | IP 65 |
Operating speed | IP 65≤12000 rpm (+20 °C) ≤11000 rpm (+40 °C) ≤8000 rpm (+60 °C) |
Starting torque | ≤0,015 Nm (+20 °C) |
Material | ≤0,015 Nm (+20 °C)Housing: aluminium die-cast Flange: aluminium Solid shaft: stainless steel |
Ambient temperature | -20...+60 °C |
Relative humidity | 90 % non-condensing |
Resistance | 90 % non-condensingDIN EN 60068-2-6 Vibration 30 g, 10-2000 Hz DIN EN 60068-2-27 Shock 300 g, 6 ms |
Explosion protection | II 3 D Ex tc IIIC T135°C Dc X (dust): see special conditions “X” |
Connection | II 3 D Ex tc IIIC T135°C Dc X (dust): see special conditions “X”Flange connector M12, 8-pin Flange connector M23, 12-pin Cable |
Weight approx. | 300 g |
8 (029) 555-8-000 | |
8 (044) 555-8-000 | |
8 (017) 255-8-000 |